Suited for Intermediate Users

LulzBot Aerostruder v2 Micro Tool Head

Reach new layer heights for snap-fit parts and tight tolerances, or save time in post processing by using minuscule layer heights as low as 0.05 mm (50 microns) with this high-precision 3D printer head.

The LulzBot SL Tool Head (Aerostruder v2 Micro) is a 3D printer extruder head that is perfect for engineers, digital artists, and designers seeking a higher level of detail and surface quality. Enjoy the convenience and reliability offered by the LulzBot ecosystem including Cura LulzBot Edition software and Marlin firmware.  Featuring layer heights less than 1/30th the thickness of a penny, think small with this LulzBot Mini 2 3D printer tool head.

[Watch the product video]

Works with: LulzBot Mini 2, LulzBot TAZ Workhorse, LulzBot TAZ Pro
  • Features

    The LulzBot SL Tool Head features a genuine E3D Titan Aero Extruder/Hot End with a 0.25 millimeter nozzle enabling out of the box 3D printing at resolutions as low as 0.05 mm layers, or 50 microns! Advanced users can achieve even finer resolutions. This high-precision 3D printer head is currently compatible with the LulzBot Mini 2 3D Printer. LulzBot TAZ users will also be able to enjoy high-detail printing with an adapter that is in development.

    A high-output centrifugal fan and quad-port cooling duct support elaborate prints with extensive bridging, cooling filament in 360-degrees before it has time to sag between points. Lightweight and compact, the SL connects to your LulzBot Mini 2 3D Printer quickly and easily to bring high-resolution 3D prints to your LulzBot 3D Printer. 

    This tool head is intended for advanced users, and produces  precision prints with impeccable detail. Some users have asked about different aspects of its capabilities: 

    What materials can be used with the LulzBot SL Tool Head? 

     You can use almost any, including flexible filaments like NinjaFlex! We STRONGLY recommend avoiding filled filaments like bronzeFill and woodFill. The particulates in these materials may be too large to pass through the nozzle. 

     Will the Z-offset need to be adjusted due to the different nozzle size? 

     For optimal first layer adhesion, you will want to adjust the Z-offset so that the nozzle tip is closer to the print surface. Follow the instructions here.

     Will I need to use an enclosure when printing with the LulzBot SL Tool Head? 

     Because the nozzle diameter is so small, print times will be longer. We recommend printing with materials engineered or naturally optimized for 3D printing, like nGen, INOVA-1800, or PLA. Alternatively, we recommend using an enclosure when printing with materials like ABS to mitigate warping/lifting.

  • Parts & Specifications

    Parts Included

    One (1) LulzBot SL Tool Head (Fully Assembled, Aerostruder v2 Micro)


    Required filament diameter: 2.85 mm diameter (3 mm)

    Hot end temperature range: 120°C - 300°C

    Filament Diameter: 2.85 mm

    Nozzle Diameter: 0.25 mm

    Required power system: 24 Volts

    Fans: (1) 5v 40 mm heat sink cooling fan, and (1) 24v centrifugal print cooling fan

    Weight: 457.8 g (1.01 lbs)

Installation Instructions LulzBot Mini 2