E3D Dual V3 Hotend Kit
These two hot end kits are direct replacements for the hot ends used in the LulzBot TAZ Dual Extruder v3 Tool Head. Each kit includes thermal compound and an assembled hot end with terminated thermistor, heater cartridge, and Z-axis probing wiring.
Please note, the left and right hot end kits are sold separately.
Each LulzBot TAZ Dual Extruder v3 Hot End uses a 24 Volt, 30 Watt heater cartridge and metal-jacketed thermistor to rapidly produce and sustain the precise amount of heat needed to produce great looking objects.
These hot ends use genuine E3D components and are compatible with E3D V6 threading.
- Parts & Specifications
1 assembled hot end, with terminated wiring harness
1 terminated Z-axis probing ground wire connector, with M3 8mm screw and locking washer
1 packet of E3D thermal compound
Note: Only the E2 hot end kit includes the single Zero Sense wire used for Z-axis probing
Additional Items Required
Machined Heat Sink, used on the LulzBot TAZ Dual Extruder v3
Terminated blue 2 pin thermistor with connector
Terminated blue 2 wire, 24 volt 30 watt heater cartridge without connector (plugs into existing 16 pin tool head connector)
Terminated red single wire Z-axis probing wire with lug (plugs into existing 16 pin tool head connector)