100k Semitech GT2 Thermistor
This 3D printer thermistor is a direct replacement for the thermistor used in the LulzBot Hexagon Hot End. Use this thermistor for applications at or below a temperature of 300℃.
Terminated with bare crimp pins for easy installation and includes heat-resistant insulation over the thermistor leads. A compatible connector housing is not included.
- Parts & Specifications
1 100k ATC Semitec 104GT-2 thermistor, terminated with bare connector pin
Temperature Range: -50℃ ～ +300℃
Recommended Connector Pin: Output (Male) Molex SL 16-02-0108
Compatible Housing: Molex SL series