Suited for Advanced Users

LulzBot SE Tool Head Hot End Kit | 0.5 mm Nozzle

This hot end kit is a direct replacement for the E3D hot end used in the LulzBot SE Tool Head (Aerostruder v2 Tool Head) found on the LulzBot Mini 2. Each kit includes a machined aluminum heat sink and an assembled hot end with wired and terminated thermistor and heater cartridge.

Product Alert (2)
  • Note:

    Please contact us for assistance before purchasing this component if you own a LulzBot Mini 2 or SE / Aerostruder v2 Tool Head and need support or repair.

  • Ordering from outside of the United States?

    Order by contacting our sales department at Sales@LulzBot.com or by phone.

Works with: LulzBot Mini 2, SE Tool Head | Single Extruder | 0.5 mm
Support: Aerostruder v2 Hot End Kit
US$12500
*NOT AVAILABLE - Get an alert when this becomes available
Enter your email address to receive an email when this product becomes available.
  • Features

    The LulzBot SE Tool Head uses a powerful 24 volt, 40 watt heater cartridge to rapidly produce and sustain the precise amount of heat needed to produce great-looking 3D prints.

    This hot end kit uses genuine E3D components and is compatible with E3D V6 threading.

  • Parts & Specifications

    Parts Included

    1 assembled hot end, with terminated thermistor and heater cartridge

    Additional Items Required

    E3D Titan Aero Extruder Components, used on the LulzBot SE Tool Head (Aerostruder v2)

    Specifications

    Blue wired thermistor with 2 pin connector

    Red wired 24 volt, 40 watt heater cartridge terminated with 2 pins, install into existing 20 pin tool head connector

  • Resources & Documentation

    Source

    Bill of Materials

    Assembled Hot End Drawing

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.