Suited for Advanced Users

Archim 2.2b Board

This all-in-one TAZ Pro 3D printer motherboard is made by UltiMachine using a 32bit Atmel SAM3X8E processor and comes equipped with Trinamic TMC2130 stepper drivers all on one integrated PCB, built in fuses, and more.

Product Alert (2)
  • Note:

    Please contact us for help before purchasing this component if you own a LulzBot TAZ Pro and would like assistance within the standard warranty period.

  • Compatibility: 

    Archim 2.2b is only compatible with the LulzBot TAZ Pro 3D Printer.

Works with: LulzBot TAZ Pro
Support: Assembled Archim 2.2b Kit
US$35000
*NOT AVAILABLE - Get an alert when this becomes available
Enter your email address to receive an email when this product becomes available.
  • Features

    Since Archim2.2 is built on the shoulders of the Arduino community, makers and hackers should consider using this motherboard for additional projects beyond controlling a 3D printer.

    Curious where the product's name comes from?  Archim is named after the mathematician Archimedes.

  • Parts & Specifications

    Parts Included

    • One (1) Archim2.2 electronics board

    Specifications

    • Designed and Manufactured by UltiMachine

    • Logic

      • Archim2 is supported in mainline Marlin Firmware as BOARD_ARCHIM

      • Crystals for both usb and mcu (timing accurate to 10ppm)

      • 4 Thermistor jacks

      • All extra pins broken out on both processors (allows using the 32u2 for LUFA AVR programmer, etc.)

      • 2 channel SDRAMPS compatible SPI breakout

    • Stepper Drivers

      • 5 TMC2130 1/8th microsteps motor drivers with 1,1/2,1/4,1/16 as options (2 connectors for Z-axis)

      • SPI (Serial Peripheral Interface) communicated motor current control (no tiny knobs to tweak)

      • Current limit on driver IC VCC to prevent permanent latchup

      • Microstep mode configured by MCU through firmware (no jumpers needed)

      • Test points for driver control signals

      • Step and Direction pins are on their own ports for synchronous movement capability

      • Extra driver ports broken out for up to 3 additional drivers (some of the motor extension pins are shared with max endstop and a pin allocated for SPI-SS extensions)

    • PWM DC outputs (Extruders, Fans, Etc.)

      • 6 outputs

      • Low resistance mosfets for cool running

      • Indicator led for each channel

    • Power

      • Three ATC fuse protected power rails

      • Heated Bed, 15A 12-35V

      • Extruders + fans and logic, 5A 12-35V (fuse can be exchanged for up to 10A capacity)

      • Motors, 5A 12-28V (fuse can be exchanged for up to 10A capacity)

      • SMPS supports hostless printing on power supply voltages from 10-24V DC

    • PCB

      • 4 layer

      • 2oz copper on all layers

      • High quality, High temperature FR4-TG130 PCB

      • Gold ENIG finishing

    • Fuses

      • 3 user replaceable automotive fuses;

        • F2: automotive-type 5A ATO bladed fuse for motors and on-board power supply

        • F3: automotive-type 5A ATO bladed fuse for extruder heater + fan outputs and logic

        • F4: automotive-type 15A ATO bladed fuse for the heated bed

  • Resources & Documentation

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.