Suited for Intermediate Users

LulzBot Mini Enclosure by Printed Solid

Minimize warping caused by drafts or cold 3D printing environments with the LulzBot Mini Enclosure by Printed Solid. This enclosure helps keep curious hands and paws away from heated and moving parts of your 3D printer. This acrylic enclosure kit can be assembled without gluing, drilling, cutting, or engraving. Separate tools and 3D printed parts are required, see more information below.

  • Features

    No gluing, drilling, cutting, or engraving is required for assembly.

    The enclosure has a modular design, meaning pieces are easily removable for access and/or printing with large spools of filament.

    The enclosure is made with optically clear, lightweight 3mm thick extruded acrylic.

    The extruded acrylic can be solvent welded, so pieces can be repaired if broken.

    There is a built-in location to mount a 40mm fan to vent air from the enclosure.

    Upgradable using your current printer, 3D print four brackets to complete the kit.

    When assembled, the enclosure sits on the same table surface as your 3D printer.

    Small footprint, adding only 105mm (4.1in) in the Y-axis (from front to back).

  • Parts & Specifications

    Parts Included

    Laser cut, extruded 3mm thick acrylic sheets

    Two (2) Part A: Front and rear panel with logo PDF SVG

    Two (2) Part B: Rear cover sides PDF SVG

    One (1) Part C: Rear cover top PDF SVG

    One (1) Part D: Rear cover bottom PDF SVG

    One (1) Part E: Front cover sides PDF SVG

    One (1) Part F: Front cover top PDF SVG

    One (1) Part G: Front cover bottom PDF SVG

    Two (2) Part H: Front and rear cover stiffener PDF SVG

    One (1) Part I: Short side cover PDF SVG

    One (1) Part J: Long side cover PDF SVG

    One (1) Part K: Top cover PDF SVG

    One (1) Part L: Optional top insert PDF SVG

    36 M3-10mm bolts

    8 M3-40mm bolts

    36 M3 square nuts

    2 M3 washers

    Printed copy of Assembly Instructions (online here)

    Additional Parts Required

    Two (2) 3D printed Mini left bracket (STL) (not included, print yourself)

    Two (2) 3D printed Mini right bracket (STL) (not included, print yourself)

    Mini left and right brackets by David Randolph and PrintedSolid.com used under the CC BY-SA 4.0 license. See recommended print settings in Step 1 of the Assembly Instructions.

    Tools Needed

    2mm hex driver

    2.5mm hex driver

    Optional: Painters tape

    Optional: Flat razor

    Time Required

    1-2 hours, based on skill level

    Physical Dimensions

    LulzBot Mini Dimensions (Standard): 435mm x 340mm x 385mm (17.1in x 13.4in x 15.2in)

    LulzBot Mini Dimensions (with Enclosure): 435mm x 445mm x 385mm (17.1in x 17.5in x 15.2in)

    Enclosure adds an additional 105mm (4.1in) in the Y-axis (from front to back).

    Warnings

    Acrylic can easily crack - do not over tighten the screws. Tighten to hold without movement.

    When cleaning, use dish soap or hand wash and a soft, clean cloth. Do not use Windex® or other glass cleaning solutions. Do not use a hard sponge, scrub, or abrasive surface.

    Windex is a registered trademark of S.C. Johnson, Inc.

    Support Information

    Have questions? Contact the sales support team by emailing Sales@LulzBot.com or by calling +1-970-377-1111.