Electronics Mount Plate

The Electronics Mount Plate, for Prusa or Mendel design Reprap 3D printers, is capable of mounting RAMPS and/or Sanguinololu electronics. The mount plate is made of 5.5mm thick clear acrylic that allows for better viewing than wooden mounting plates. Also, you have no worries of slicing your arm open on a sharp acrylic corner as the plate has rounded edges.

This part only includes the acrylic plate. If you would like all of the hardware and parts needed see the Electronics Mount Plate Kit.

**Frosted Acrylic Electronic Mount Plates are available. They are the same as the clear, but have frosting on one side. Choose Clear or Frosted in the product selector.**

Specifications

• Capable of mounting RAMPS and/or Sanguinololu electronics
• 5.5mm thick clear acrylic
• Size: 28cm x 9cm x 5.5cm
• Rounded corners

Sources

Wiki page

Thingiverse part